Save Your Plumbing - GLECO Trap to the Rescue!

• The Gleco (pronounced glee-co) Trap is an innovative, economical solution to messy, hard-to-use clay traps.
• Plumbing trap is easily installed and maintained.
• Trap connects below the sink to collect solids in a bottle, which has a fill line.
• When the solids reach the fill line, the trap is drained through the valve, the bottle is then exchanged with a replacement bottle
• The valve shut and the trap is back in service.
• Bottle exchange is rapid (less than 2 minutes!) and done without tools. There is no mess and less chance of water spillage.

When measuring for your trap, check the distance from the middle of the pipe going into the wall to the floor or cabinet bottom.

Height of unit minimum recommended

BGGT19 10 ½” 11 ½” 13”

BGGT64 14 ½” 15 ½” 17”

The Gleco Trap Package is available in three sizes:

GT64 TEMPORARILY UNAVAILABLE FROM MANUFACTURER is the most popular Gleco Trap Package and will easily fit under most standard sink areas with at least 15-1/2" from waste line to floor (17" recommended). GT64 package includes:
2 • 64 ounce bottles
1 • Lid for extra bottle
1 • 1-1/2" x 8" sink tailpiece
2 • 1-1/2" slip-joint washers
4 • 1-1/2" slip-joint nuts
1 • 1-1/2" flat washer
1 • Extra O-ring
Complete instructions.

GT43 TEMPORARILY UNAVAILABLE FROM MANUFACTURER Maximize your volume capacity in small spaces. This package requires a minimum space of just 13" from waste line to the floor (14.5" recommended). GT43 package includes:

2 • 43 ounce bottles
1 • Lid for extra bottle
1 • 1-1/2" x 8" sink tailpiece
2 • 1-1/2" slip-joint washers
4 • 1-1/2" slip-joint nuts
1 • 1-1/2" flat washer
1 • Extra O-ring
Complete instructions

GT19 is perfect for deep utility sinks and tight spaces and requires a minimum of just 11-1/2" from waste line to the floor (13" is recommended).GT19 package includes:
2 • 19-ounce bottles
1 • 32-ounce bottle (for draining)
1 • Lid for extra bottle
1 • 1-1/2" x 8" sink tailpiece
2 • 1-1/2" slip-joint washers
4 • 1-1/2" slip-joint nuts
1 • 1-1/2" flat washer
1 • Extra O-ring
Complete instructions

When the bottle on the Gleco Trap is full, you have two options: 1. dispose of the sediment and reuse the bottle. 2. dispose of the sediment and the bottle and purchase replacement bottles. The choice depends on your particular situation.* 

* If you work with plaster or other substances that harden even in water, it is necessary to dispose of the bottle.

8/23